RASPTOUCH
To start, take the smal bag including the 2 squares of thermal paste, their holding plate as well the
screw. Place the holding plate and the screw (turn the case and screw from the bottom), then
place the thermal paste. It should look as in this picture:
9 – Thermal paste + holding plate…
The Raspberry Pi wiil then stick to it. The location is provided so that it lands perfectly where the
heat is to be dissipated. (Please dont forget to remove the protection from the thermal paste.)
10 – « Raspberry Pi + DAC ES9023»…
Once the Raspberry Pi and the ES9023 DAC are in your hands, it is necessary to assemble both in
order to integrate them in the case later.
O assemble the Raspberry Pi and the DAC, retrive the spacers and the nuts found in your package,
assemble the whole as in the following picture:
Page 13 sur 29
