MT10A / MT12A / MT15A - 10/12/15 inches 2-way amplified speakers with bass reflex
Page 5
English
1
Power input
Allows you to connect the speaker to an electrical outlet.
Use the supplied IEC cord, and make sure the voltage
delivered by the outlet is in adequation with the value
indicated by the voltage selector before turning on the
built-in amplifier.
2
Fuse
Protects the power supply module and the built-in
amplifier.
If need to replace the fuse, please make sure the new
fuse has exactly the same characteristics.
3
Power switch
Allows you to turn ON/OFF the amplifier.
4
Voltage selector
Allows you to adapt the voltage of the amplifier to the
voltage of the electrical outlet.
Power supply zone
Control panel
5
MIC/LINE input via COMBO connector
The COMBO connector allows you to connect either a
male XLR plug, or a male Jack mono or stereo connector.
This line level input is balanced.
Please refer to the following chapters for more details
about the different wiring.
6
LINE/MIC selector
Allows you to adapt the incoming impedance to the type
of signal.
When pressed, the input level is adapted to microphone
signals, otherwise it is adapted to line level signals.
7
MIC/LINE fader
Allows you to configure the MIC or LINE input level.
Please make sure the SIG/CLIP LED is not lit for long
periods to ensure an optimal sound quality.
8
LINE input via COMBO connector
This combo socket allows you to plug either a male XLR
or male mono/stereo Jack.
This line level input is balanced.
Please refer to the following chapters for more details
about the different wiring.
4 - Presentation of the unit
1
3
4
2
5
6
12
11
9
8
10
7
13
14
15
