MT10A / MT12A / MT15A - 10/12/15 inches 2-way amplified speakers with bass reflex
Page 6
English
9
LINE/AUX fader
Allows you to configure the LINE or AUX input level.
Please make sure the SIG/CLIP LED is not lit for long
periods to ensure an optimal sound quality.
10
LINE/AUX selector
Allows you to selec either the LINE input (COMBO
socket) or the AUX input.
When not pressed, the incoming signal from the
COMBO socket is sent to the amplifier, otherwise the
AUX signal will be sent to the amplifier.
11
AUX input
Line level input via Jack 3.5;
Allows you to retrieve the signal of, for instance, an MP3
player.
12
Equalization zone
These two faders allow you to adjust the bass and treble
settings from -15dB to +15dB.
These adjustments affect the MASTER part of the signal.
13
LED POWER
This LED is lit when the built-in amplifier is turned ON.
14
LED SIG/CLIP
This LED has two functions:
- It lits in yellow when a signal is detected on one of the
two inputs.
- It lits in red when the sum of each signal levels exceeds
0dB.
Please make sure the SIG/CLIP LED is not lit for long
periods to ensure an optimal sound quality.
15
XLR LINE OUT
socket
Allows you to retrieve the sum of each incoming signal
and transmit it to another amplified speaker, mixing
desk, or speaker/amplifier system.
5 - Connectors
2 = Hotspot (+)
2
3
1
3 = Coldspot (-)
1 = Ground
2 = Hotspot (+)
2
3
1
Shunt between
1 and 3 pins
1 = Ground
Tip
Tip
Signal
Sleeve
Sleeve
Ground / Shield
Ring
Ring
Coldspot (-)
Tip
Tip
Hotspot (+)
Sleeve
Sleeve
Ground / Shield
5.2 - Unbalanced
5.1 - Balanced
The COMBO sockets are
symetrical. This type of
connectors allows you to transmit
a signal over long runs of cables
without altering its quality, that
is why we recommend to use
symetrical signals.
The figures opposite describe
the balanced wiring of the XLR or
Jack 6.35 plugs.
If you do not have any source
with symetrical signal, please do
not use cables longer than 1.5 m.
The figures opposite describe the
unbalanced wiring of the XLR or
Jack 6.35 plugs.
