10. Battery power input #1 (XLR4M)
11. Battery power input #2 (XLR4M)
CONNECTORS WIRING:
•
Hirose 4 pin power output connectors (power paths 4,5,6,7,8 and 9)
◦
1 :
DC -
◦
2 :
Not connected
◦
3 :
Not connected
◦
4 :
DC +
•
XLR 4 pin power output connectors (power paths 1,2,3 and 10)
◦
1 :
DC -
◦
2 :
Not connected
◦
3 :
Not connected
◦
4 :
DC +
•
FRONT USB power ports (500mA charging current)
◦
1 :
Vcc (5V)
◦
2 : 2.0V (thru dividing resistors)
◦
3 : 2.0V (thru dividing resistors)
◦
4 :
GND
•
REAR USB power ports (1000mA charging current)
◦
1 :
Vcc (5V)
◦
2 : 2.8V (thru dividing resistors)
◦
3 : 2.0V (thru dividing resistors)
◦
4 : GND
PLEASE NOTE :
The USB ports are configured to allow charging of Apple devices and most other
smartphones. This feature is not available on early units shipped prior to september 2013. Please
contact your dealer if you wish your unit to be updated with this feature.
For units shipped after February 1
st
2014 the 2 front USB ports can charge an iDevice or other
smartphone with a current of up to 500mA. The rear USB ports of the K-ART charge an iDevice or
other equipement with a current of up to 1000mA.
•
XLR 4 pin battery input connectors (batt 1 and 2)
◦
1 :
DC -
◦
2 :
eSMART DAT
◦
3 :
eSMART CLK
◦
4 :
DC +
WARNING : Pins 2 and 3 of the XLR 4 battery input connectors should never be connected to
pin 4 (DC+) or the internal fuel gauge could be destroyed. Please check wiring of your power
cables prior to use with the eSMART K-ART.
http://www.audioroot.fr
audioroot@audioroot.fr
Ce document est la propriété d'AUDIOROOT, et ne peut-être reproduit ou communiqué sans autorisation
