AudioSonic TXCD-1530 Instruction Manual Download

Page: 9 / 112

• Press program key once.
• Press

to select desired memory position. (there are 10 memory

positions for am band & 30 memory positions for fm band).

• Press program key once to save the selected station into the selected memory

position.

• To recall any saved memory, simply press

, the saved radio-band will

be recalled.

• To clear the memory of any position, simply save a new station to the same

memory position.

INSERTION AND REMOVAL OF DISCS

Press the "function" key repeatedly until the display shows "cd". press the open/ close
key to open the cd-door. carefully place acompact disc (cd or mp3 disc) onto the
center spindle with the label side (printed side of disc) facing outwards (towards you).
Press the "open/ close" button to automatically close the cd-door. The cd-display will
show the total number of tracks on the disc after a few seconds. The cd is now ready
to be played. to remove a disc, press the open/ close key. The door will open upwards
allowing the removal of the cd inside.

Important: Always hold a cd by it's edges. avoid getting any finger-prints,

smudges or dirtonto the surface ofadisc. in case this happens, use a special

cd-cleaning cloth or cleaning kit to remove the dirt or smudges.

NORMAL CD OPERATION

•  Press "ON/OFF" key to switch on the unit.
•  Press the "function" key repeatedly until the display shows "cd"
•  Press the "open/ close" key & insertacdas described.
•  Press play key. the disk will start spinning & the first
•  Song (track) will start playing. the display will indicate the current track no.

• At any anytime during playback, press the play key
• To pause operation of the unit. press play key to resume operation at the same

track & position.

• At anytime during playback, press the stop key to stop operation of the set. this

will reset the set to the first track (if you press play after stop, the first track will
always start playing).

• At anytime during playback, press and reiease the next or back keys to skip

forward or backwards by one track, as desired.

• Any anytime during playback, press and hold the next or back keys to fast-

forward (cue) or fast-reverse (review) the specific track, which is currently playing.

Programming the cd-player

•  The cd player can be programmed to play any sequence of upto 64 tracks, as desired.
•  Always press the stop key before starting the programming.
•  Press the program key once, the display will show the "memory" symbol to

indicate that the set is now in "memory programming mode".

For normal cd-audio discs:

• Press the next or back to select the track (song) number you wish to be stored in

the current memory (program) position.

• Press the program key to confirm your selection.
• Repeat the previous 2 steps, each time selecting any track number of your choice

to be stored in successive (program) positions.

• After a maximum of 64 songs (or less) have been selected as described above,

press program key, the display will now show memory to indicate you have saved
a program-memory.

• Press play key, the cd-player will playback the "saved sequence" in the program

memory.

• To clear (cancel) the entire program which is stored in the memory, simply press

stop key, this will reset the memory & clear the program.