www.audiosource.net
FCC Statement
This device complies with Part 15 of the
FCC Rules.
Operation is subject to the following
two conditions:
(1) This device may not cause harmful
interference, and
(2) this device must accept any
interference received,
including interference that may cause
undesired operation.
Any changes or modifications not
expressly approved by
party responsible for compliance could
void the user’s authority to operate the
equipment
Important Notice!
Please use the special tab
on the suction cup to remove it
from the surface it is adhered to.
Please do not try to pull
Sound pOp 2™ off by pulling on the
body as it could damage the unit.
Please note that the suction cup
adhesion time will vary depending
on the surface it is attached to.
Surface texture, temperature, and
debris can all reduce adhesion time.
@SoundpOpAudio
Like Us!
/SoundpOpAudio
Follow Us!
尺寸：80-MD101-97-2126-01 2014-9-9
Warning: Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
FCC WARNING
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
FCC STATEMENT
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
IF FCC ID could not be found on
the silicon shell, you might find
the same marking
FCC ID: 2AC6P-SOUNDPOP2 on
plastic shell by removing the
silicon.
