29
1.1 General installation instructions
To prevent damage to the unit and possible injury, read this manual carefully and follow all installation instructions. This
product has been checked for proper function prior to shipping and is guaranteed against manufacturing defects.
Before starting your installation, disconnect the battery’s negative terminal to prevent damage to the unit, fire
and / or risk of injury.
For a proper performance and to ensure full warranty coverage, we strongly recommend to get this product installed by
an authorized BRAX, HELIX or MATCH dealer. Install your DIRECTOR in a dry location with sufficient air circulation for
proper cooling of the equipment.
For safety reasons the DIRECTOR must be installed professionally to prevent hazard to the vehicle and / or risk
of injury to the passengers during a critical driving situation such as an emergency braking.
The remote control should be secured to a solid mounting surface using proper mounting hardware.
Attention:
During assembly make sure that the DIRECTOR cannot interfere with any safety system of the car (e.g.
airbags).
•
Do not mount the remote control on faceplates of airbags (e.g. steering wheel or car dashboard)
•
Do not mount the DIRECTOR in the view field of the driver
•
Do not place the remote control unsecured on top of the dashboard
Before mounting, carefully examine the area around and behind the proposed installation location to ensure that there
are no electrical cables or components, hydraulic brake lines or any part of the fuel tank located behind the mounting
surface. Failure to do so may result in unpredictable damage to these components and possible costly repairs to the
vehicle.
Prior to installation, plan the wire routing to avoid any possible damage to the wire harness. All cabling should be pro
-
tected against possible crushing or pinching hazards. Also avoid routing cables close to potential noise sources such as
electric motors, high power accessories and other vehicle harnesses.
1. General instructions
