Audiotec Fischer MATCH UP C42MB-FRT, Manual

9

Dear Customer,

Congratulations on your purchase of this high- 

quality MATCH speaker system. 

This system highlights best quality, excellent manu

-

facturing and state-of-the-art technology. 

Thanks  to  more  than  30  years  of  experiences  in 

research and development of audio products this 

speaker system generation sets new standards.

We wish you many hours of enjoyment with your 

new MATCH speakers.

Yours
AUDIOTEC FISCHER Team

General instructions for MATCH UPGRADE 

speaker systems for Mercedes vehicles

The MATCH UPGRADE speaker systems for 

 Mercedes vehicles are semi-active speaker sys-

tems. Therefore it is mandatory to use an amplifier 

to drive these speakers (e.g. MATCH UP 7DSP).

When using the midrange speakers ( UP S4MB-FRT, 

UP X4MB-FRT, UP S4MB-SUR, UP S4MB-CTR) 

we recommend to use a highpass filter of 150 Hz / 

12 dB and for the subwoofers (UP W8MB-S4) a 

lowpass filter of 150 Hz / 12 dB.

General installation instructions for MATCH 

components

To prevent damage to the speakers and possible in-

jury, read this manual carefully and follow all instal-

lation instructions. This product has been checked 

for proper function prior to shipping and is guaran-

teed against manufacturing defects.

For a proper performance and to ensure full war-

ranty coverage, we strongly recommend to get this 

product installed by an authorized MATCH dealer.

General instruction for installing MATCH 

speaker systems

The method of installation chosen and level of ex

-

ecution  will  effect  the  overall  performance  of  the 

speaker system. Treat each installation step with a 

high degree of attention.

We strongly recommend that you operate the com-

plete  audio  system  at  low  volume  before  final  in

-

stallation. This will allow a trial listening test before 

securing the loudspeakers into their mounting loca-

tions.

Install the cabling in a manner which precludes any 

danger of the leads being exposed to shear, crush

-

ing or rupture forces. If there are sharp edges in the 

vicinity (e.g. holes in the bodywork) all cables must 

be cushioned and protected to prevent fraying.

Make sure that all speaker wires easily reach the 

speaker terminals without stress on the wire or con-

nectors.

Once you have tested the complete speaker 

system and have confirmed correct operation, turn 

the audio system off and prepare the loudspeaker 

for final mounting.

Further installation guides at 

www.audiotec-fischer.com

Congratulations!

General instructions