TROUBLE SHOOTING GUIDE
Should and problem persist after you have made the following checks, consult your nearest service
facility.
Disc play does not start :
•
The disc is inserted upside down or incorrectly. Insert the disc correctly with the label surface up
•
Dusty or defective disc
•
Dirty or dusty lens
•
The disc compartment lid is not close.
•
Moisture condensation -> Leave the unit in a warm place until the moisture evaporates
•
The AC power adaptor is not plugged into the wall outlet
•
The unit is not placed on a level surface
•
Weak batteries
No sound from the headsets :
•
The headphones / earphone plug is not firmly connected to the
“PHONES”
jack
•
Adjust the
“VOL”
control
•
Dirty plug
No sound from the connected speakers :
•
Check the connections
•
The amplifier is not turned on
Skipping of sound :
•
Dirty or defective disc
•
Dirty lens
•
Strong vibration
When using with batteries the battery life is short :
•
Manganese batteries are used. Use alkaline batteries.
Display windows shows “
” error message and the unit cannot be
operated :
•
No disc, dirty disc or scratched disc. The unit will return to full stop mode after approx. 30 seconds, or
reset the player by pressing
“
”
once and then insert a disc to start playing.
MAINTENANCE
Cleaning the unit
Do not use volatile chemicals on this unit. Clean by lightly wiping with a soft cloth.
Cleaning CD
If the CD skips or will not play, the disc may need to be cleaned. Before playing, wipe the disc in a
circular motion from the centre out with a cleaning cloth. After playing, store the disc in its case.
Handing the disc
Only touch the CD on the edge to avoid finger prints on its surface. Do not stick paper or tape nor write
anything on the surface.
SPECIFICATIONS
General
Output (at 1KHz 0db level) Headphones / earphone (stereo minijack)
15 mW + 15mW at 16
Ω
to 32
Ω
Power requirements
2 size “AA” (LR6 or SUM-3) alkaline batteries; or DC in 6V, 350mA power
adaptor
Polarity of plug
Dimensions
Approx. 129 x 30 x 142mm (W/H/D)
Weight
Approx. 225g (not include batteries)
Operating voltage
U.S.A., CANADA
:
120V AC
±
5% 60 Hz
MIDDLE EAST and AUSTRALIA
:
240V AC
±
5% 50 Hz
UK and GERMANY
:
230V AC
±
5% 50 Hz
CHILE
:
230V AC
±
5% 50 Hz
SINGAPORE, MALAYSIA & THAILAND :
200 - 240V AC
±
5% 50 Hz
JAPAN
:
100V AC
±
5% 50/60 Hz
Design and specifications are subjest to change witout notice.
Play mode of the second track
VARIOUS PLAYING MODES
During playback, every time the
“PLAY MODE”
key is pressed, the mode would be changed to the next
one as follow :
NORMAL PLAY
->
INTRO
->
SINGLE MUSIC
->
PROGRAM (PGM)
->
RANDOM(RND)
*Repeat play of each mode is possible.
NORMAL PLAY
- Playing the whole disc
There is no play mode indication in the display window. To repeat the
whole disc, press
“REPEAT / ENTER”
.
INTRO PLAY - Playing the first about ten seconds of all the selections
1. Press
“PLAY MODE”
during play until
“
”
disappears in the display
window.
2. P r e s s
“ P L AY M O D E ”
t o b e g i n t h e
“ I N T R O ”
p l a y,
“ ”appears again in the display window.
3. Pressing
“
”
again will cease the
“INTRO”
play and continue
playback in the NORMAL play mode.
SINGLE MUSIC - Playing only one selection
1. Press
“PLAY MODE”
during play until the track number flashes.
2. Select desired track to be played only once by pressing
“
”
or
“
”
.
3. To play only repeatedly, press
“REPEAT / ENTER”
.
PGM (Program) PLAY - Playing the selections in the desired order
1. Press
“PLAY MODE”
during play until
“PGM”
flashes in the display
window.
2. Press
“
”
or
“
”
to select the desired selection.
3. Press
“REPEAT / ENTER”
to register track no. 4 for example, as
the first selection. The track no. indication will be returned to
“
”
.
4. Repeat step 2 and 3.
5. Press
“
”
,
“PGM”
stops flashing and program play starts.
*
To repeat program play, press
“REPEAT / ENTER”
.
*
If
“
”
is pressed or if the lid as opened, all the programs would be cleared.
*
If the program mode is exited by means of the
“PLAY MODE”
key, all the programs would still
remain in memory.
Program edition
To check
: Press
“REPEAT / ENTER”
lightly during programming before you press
“
”
.
Each time
“REPEAT / ENTER”
is pressed the track number appears in the display
window.
To change
: When checking press either
“
”
or
“
”
to alter track number for the program
currently displayed. Press
“REPEAT / ENTER”
to register the newly selected track
into memory.
To erase
: When checking, if the track numer of a program is selected as
“
”
, all the
subsequent programs starting from and including that program will be cancelled.
SHUFFLE PLAY - Playing the selections in random order
Press
“PLAY MODE”
until
“
RND
”
appears in the display windows.
Random play starts from the next track, or when
“
”
is pressed.
Some swivelling symbols will be shown on the CD display and a short
period of time is needed for track shuffling.
To play the selections in random order repeatedly, press
“REPEAT /
ENTER”
. After every selection has been played in random order, they will be reshuffled and played
repeatedly in a different order each time.
*
To locate the beginning of the track being played : press
“
”
.
*
To locate the next track : press
“
”
. However, you cannot locate
a previous track even if you keep
“
”
pressed.
REPEAT PLAY - Playing the whole disc continuously
To repeat the whole disc, press
“REPEAT / ENTER”
will appear in the
display window.
RND
RND
RND
PGM
PGM
PGM
PRINTED IN CHINA
8 11 - 8 7 0 0 9 1 - 1 7 0
