Your AA-RS20CS Remote Start Alarm System has many features and available options
some of which are selected at time of installation. For your reference, the list on the back
page of this manual show what features and options have been installed. Consult your
installing dealer for options that may have been installed and are not listed.
ARMING THE SYSTEM - ACTIVE:
1. Turn the engine off, exit the vehicle, and close all doors, hood and trunk.
2. Press and release transmitter button 1 one time.
The parking lights will flash once, the siren will chirp once, and the dash
mounted LED will begin to flash slowly confirming the system is armed.
If you have the optional door lock/unlock circuit installed, the doors will lock.
Note: If the siren chirped three times, then you have left a door, hood, or
trunk ajar. Simply closing that opening will provide full protection. If the
siren did not sound when arming, then the chirps have been turned off.
Refer to the section on "Eliminating the Arm/Disarm Chirps" shown later
in this manual.
SILENT ARMING - ACTIVE:
1. Turn the engine off, exit the vehicle, and close all doors, hood and trunk.
2. Press and hold transmitter button 1 for two seconds.
The parking lights will flash once, and the dash mounted LED will begin to flash slowly
confirming the system is armed. The siren will not chirp. If you have the optional door
lock/unlock circuit installed, the doors will lock.
Note: If the siren chirps three times, then you have left a door, hood, or trunk ajar. Simply
closing that opening will provide full protection.
ARMING THE SYSTEM - PASSIVE (AUTOMATIC)
If the passive arming feature has been selected:
1. Turn the engine off, exit the vehicle, and close all doors, hood and trunk.
The dash mounted LED will begin to flash rapidly indicating that the 30 second passive
arming timer has begun. If the LED does not begin to flash rapidly, then you have left a
door, hood, or trunk ajar. Closing this entry point will allow the arming cycle will begin. If
any entry point is opened during the 30 second arming cycle, arming will be suspended.
When all entry points are closed, the arming cycle will begin again.
At the end of the 30 seconds, The parking lights will flash once, the siren will chirp once,
and the dash mounted LED will begin to flash slowly confirming the system is armed. If
the siren did not sound when arming, then the chirps have been turned off. Refer to the
section on "Eliminating the Arm/Disarm Chirps" shown later in this manual. Passive door
locking is a selectable feature. If you have the optional door lock/unlock circuit installed,
the doors may or may not lock passively dependent upon the setup during installation.
PROTECTION WHILE THE SYSTEM IS ARMED:
Opening any protected entry point, hood, trunk, or doors will cause the alarm to trigger
immediately. The siren will sound and the parking lights will flash for 30 seconds, then
stop and continue to monitor all protected entry points. If the thief left the door opened,
the unit will sound for six 30 second cycles than shut down, isolate the triggered zone and
Page 2
1
2
3
