background image

continue to protect all other zones.
Whenever the system is armed, the dash mounted LED will slowly flash.  This serves as
a visual deterrent to a potential thief.  This LED is a very low current light emitting diode,
and will not cause the battery to drain even if left unattended for long periods of time.
Whenever the system is triggered, the vehicle parking lights will flash for the full siren
sounding period. Optional - whenever the system is triggered, the interior courtesy light
will flash for the full siren sounding period.
Whenever the system is armed, the vehicle starter circuit is disabled, even with the igni-
tion key the vehicle will not start.
Whenever the system is armed, any strong impact to the vehicle will cause the shock
detector to trigger the alarm.  Any lesser impact will cause the pre-detect stage of the
shock sensor to emit a few short series of warning tones from the siren.

DISARMING THE SYSTEM
As you approach the vehicle, press and release transmitter button 1 one time.
The parking lights will flash two times, the siren will chirp twice, and dash mounted LED
will turn off.
If you have the optional door lock/unlock circuit installed, the doors will unlock. If you
have the optional entry illumination circuit installed, the interior light will turn on for 30
seconds or until the ignition key is switched on.
Note: If the passive arming mode was selected at time of installation, the dash mounted

LED will start flashing rapidly indicating that the system is rearming.  Opening any
door will suspend the automatic arming.

If the parking lights flashed three times, and the siren chirps four times, this indicates that
the alarm system had been triggered in your absence.  Before turning on the ignition key,
examine the dash mounted LED's flash pattern.  The number of flashes identifies the
triggered zone.  For additional information, refer to INTRUSION WARNING SIGNALS
found later in this manual.
If the siren did not sound upon disarm, then the chirps have been turned off.  Refer to the
section titled ELIMINATING THE ARM/DISARM CHIRPS.

SILENT DISARMING
1. As you approach the vehicle,  press and hold transmitter button 1 for two seconds.
The parking lights will flash twice, and the dash mounted LED will turn off confirming that
the system is disarmed.  The siren will not chirp.  If you have the optional door lock/unlock
circuit installed, the doors will unlock.  If you have the optional entry illumination circuit
installed, the interior light will turn on for 30 seconds or until the ignition key is switched on.
Note: If the passive arming mode was selected at time of installation, the dash mounted

LED will start flashing rapidly indicating that the system is rearming.  Opening any
door will suspend the automatic arming.

If the parking lights flashed three times, and the siren chirps four times, this indicates that
the alarm system had been triggered in your absence.  Before turning on the ignition key,
examine the dash mounted LED's flash pattern.  The number of flashes identifies the
triggered zone.  For additional information, refer to INTRUSION WARNING SIGNALS
found later in this manual.

Page 3

Summary of Contents for AA-RS20CS









Reviews: