Audiovox ACC56M, Owner'S Manual And Installation Manual

This CD Changer is designed to be operated only on 12 volt DC negative ground systems.
The unit cannot be used on 24 volt or positive ground systems.

Temperature

The unit may not operate correctly in extremely hot or cold temperatures. It is equipped
with a built-in thermal protection circuit which will stop operation of the unit when the
temperature reaches the preset level. If this should happen, the unit will resume operation
when the vehicle returns to a normal temperature range. Remove the magazine from the
unit when it is not being used during hot weather. If the CD changer is not used for long
periods of time, remove the compact discs from the magazine, and store them in their
cases.

Condensation

Moisture can condense on the laser lens of the CD changer during rainy and humid days, If
this should happen the unit will not operate correctly. To remedy the situation, remove the
discs from the unit and wait approximately one hour. During this time the moisture will
evaporate and the unit will operate normally.

Interruptions in sound(Skipping)

The sound from the unit may "skip" and be interrupted if the anti-vibration springs are not
set correctly, if the changer is mounted on-end or upside-down, or when travelling on very
rough surfaces. If this should occur, check for errors made during installation or wait for the
surface to improve.

3’’(8 cm) CD-Singles

This unit is not designed to play 3" (8cm) CD-Single discs. Inserting a 3" disc into the
magazine, either with or without a 3" disc adaptor, can damage the changer and the disc.
Such damage will not be covered by the Warranty on this product.

1 1

1 0

HINTS FOR CORRECT AND SAFE OPERATION

HANDLING THE DISCS

Dirt, dust, scratches and warpage cause sound skips during playback and a deterioration of
sound quality. To take proper care of your discs:

1.Use compact discs that have the               logo.

2.Fingerprints and dust should be carefully wiped off the disc's signal surface(glossy  

side)with a soft cloth. Unlike conventional records, the compact disc has no grooves to 
collect dust and microscopic debris, so gently wiping with a soft cloth should remove most  
particles. Wipe in a straight motion from the inside to the outside of the disc. Small dust
particles or light stains will have absolutely no effect on reproduction quality.

3.Never use such chemicals as record sprays, antistatic sprays or fluids, benzine or 

thinner to clean compact discs. Such chemicals could irreparably damage the disc's  
plastic surface.

4.Discs should be put back in their cases after use to avoid serious scratches that could  

cause  the sound to skip.

5.Do not expose discs to direct sunlight, high humidity, or high temperatures for extended  

periods of time. Long exposure to high temperatures can warp the disc.

6.Do not stick paper, labels, or tape on the disc surface.

7.Do not write with any type of pen, pencil, or marker on the disc surface.

8.To minimize fingerprints and smudges on the signal surface, always try to hold the discs 

by their outer edge and center hole.