background image

128-6601

1 of 4

Page 1

Model AS 9075a

Owner’s Manual

Remote Start

 Upgrade Module

FEATURES :

w

 Remote Start Safety Control Switch

w

 Selectable Automatic Timed Start Mode (2 Or 4 Hours Selectable intervals)

w

 On-Board Start Relay

w

 On-Board Accessory Relay

w

 On-Board Ignition 1 Relay

w

 On-Board Ignition 2 Relay

w

 Ignition 2 Relay Selectable On or Off During Cranking

w

 On-Board Parking Light Relay

w

 Ignition 3 / Shock By-Pass / GM VAT Output (relay required)

w

 Tach Signal Learning Circuitry

w

 Two ( + ) and Two ( - ) Safety Shutdown Circuits

w

 Alarm By-Pass Outputs

w

 Selectable Steady or Flashing Parking Lights for Run Indication

w

 Selectable 10 or 15 Minute Run Time

w

 Factory Keyless Upgrade Inputs (Allows Starting From Factory Keyless Entry Unit)

w

 4 Auxiliary Outputs To Allow Control Of A Factory Alarm

w

 Diesel Glow Plug Preheat Mode select

CAUTION!

Be certain that the vehicle is outdoors before using this or any re-
mote vehicle starting device.  A running engine produces dangerous
carbon monoxide fumes which can be harmful or fatal if prolonged
exposure occurs.  DO NOT remote start the vehicle if the car is
garaged.

Summary of Contents for AS 9075a

Page 1: ... w Tach Signal Learning Circuitry w Two and Two Safety Shutdown Circuits wAlarm By Pass Outputs w Selectable Steady or Flashing Parking Lights for Run Indication w Selectable 10 or 15 Minute Run Time w Factory Keyless Upgrade Inputs AllowsStartingFromFactoryKeylessEntryUnit w 4 Auxiliary Outputs To Allow Control Of A Factory Alarm w Diesel Glow Plug Preheat Mode select CAUTION Be certain that the ...

Page 2: ... To select between 2 or 4 hour start up timer 1 Begin with the control switch in the on position 2 Turn the ignition switch on then off 3 Within 10 seconds move the control switch off on off on 2 switch cycles to select a 2 hour start timer After 10 seconds expire the parking lights will flash 2 times confirming that the two hour start cycle is set Or within 10 seconds move the control switch off ...

Page 3: ... will continue to run on it s own power NOTE The engine will stop running before the expiration of the pre pro grammed run timer if you complete any of the following 1 Pressing the proper button or buttons of your keychain transmitter while run ning under control of the remote start system will turn the vehicle off 2 Depress the brake pedal 3 Open the hood 4 Move the red handled control switch to ...

Page 4: ...rans mitter To do this 1 Start the vehicle using the keychain transmitter by pressing and releasing the remote start transmitter button s 2 Shut off the vehicle using the keychain transmitter by pressing and releasing the remote start transmitter button s 3 Within 10 seconds of step 2 activate the RF start command two times The parking lights will flash 4 times indicating the timed start mode is a...

Reviews: