background image

128-6601

4 of 4

FUNCTION SETTING CHART

To be completed by installer

Lights

Steady 

o

Pulse 

o

Run Time

10 Min. 

o

15 Min. 

o

TO BEGIN THE AUTOMATIC START UP TIMER

1. Turn the ignition key on then off.

2. Within 10 seconds, activate the RF start command two times.

The parking lights will flash 4 times indicating the timed start mode is activated.

The vehicle, on a 2 or 4 hour interval basis, will automatically start, run
for  the  pre-programmed time (10 of 15 minutes), and then shut off.  This will
continue for 48 hours.

NOTE: The automatic start up timer can also be initiated from the keychain trans-
mitter.
To do this:

1. Start the vehicle using the keychain transmitter by pressing and releasing the

remote start transmitter button'(s).

2. Shut off the vehicle using the keychain transmitter by pressing and releasing

the remote start transmitter button'(s).

3. Within 10 seconds of step 2, activate the RF start command two times.

The parking lights will flash 4 times indicating the timed start mode is activated.

CANCELING THE AUTOMATIC START UP TIMER
To cancel the automatic start up timer do one of the following;

1. Start the vehicle manually with the use of the ignition key and depress the
brake pedal.

2. Remote start the vehicle using your keychain RF transmitter.
And then

3. Shut off the vehicle using the keychain RF transmitter.

150 Marcus Blvd., Hauppauge NY 11788

®

(516) 231-7750

128-6601

Summary of Contents for AS 9075a

Page 1: ... w Tach Signal Learning Circuitry w Two and Two Safety Shutdown Circuits wAlarm By Pass Outputs w Selectable Steady or Flashing Parking Lights for Run Indication w Selectable 10 or 15 Minute Run Time w Factory Keyless Upgrade Inputs AllowsStartingFromFactoryKeylessEntryUnit w 4 Auxiliary Outputs To Allow Control Of A Factory Alarm w Diesel Glow Plug Preheat Mode select CAUTION Be certain that the ...

Page 2: ... To select between 2 or 4 hour start up timer 1 Begin with the control switch in the on position 2 Turn the ignition switch on then off 3 Within 10 seconds move the control switch off on off on 2 switch cycles to select a 2 hour start timer After 10 seconds expire the parking lights will flash 2 times confirming that the two hour start cycle is set Or within 10 seconds move the control switch off ...

Page 3: ... will continue to run on it s own power NOTE The engine will stop running before the expiration of the pre pro grammed run timer if you complete any of the following 1 Pressing the proper button or buttons of your keychain transmitter while run ning under control of the remote start system will turn the vehicle off 2 Depress the brake pedal 3 Open the hood 4 Move the red handled control switch to ...

Page 4: ...rans mitter To do this 1 Start the vehicle using the keychain transmitter by pressing and releasing the remote start transmitter button s 2 Shut off the vehicle using the keychain transmitter by pressing and releasing the remote start transmitter button s 3 Within 10 seconds of step 2 activate the RF start command two times The parking lights will flash 4 times indicating the timed start mode is a...

Reviews: