Audiovox AXT-2411, User Manual

- 11 - 

Battery pack

(DC 9V/300mA         adaptor)

Power Jac k

Tele phone Jac k

Line Cord

INSTALLATION

Connecting Your Phone

This section is a reference guide to the basic functions and operations of your cordless telephone. For more detailed descriptions of the 

operations and features of this telephone, refer to the   

Contents on page 2. 

1.  Carefully remove your cordless telephone from its shipping carton. If there is any visible   

damage, do not attempt to operate this equipment. Return it to the place of purchase. 

2.  Check to be sure you have all items that come with this cordless telephone system. You   

  should have one Handset, One Base Unit,  one  AC ADAPTOR,  

       one  Battery Pack, Telephone Line Cord, and Owner’s Manual. 

POWER  CONNE CTION

CAUTION: 

For BASE Unit - Use only Class II, 120 Volt AC / 9V DC Adaptor, 300mA.   

            The center tip must be positive and the plug must correctly fit the unit’s DC 9V jack.   

1.  Insert the small plug on the end of the AC ADAPTOR into the Power-In Connection Jack   

at the back of the Base Unit or Charger Unit. 

2.

Plug the AC ADAPTOR into a 120V AC wall outlet. 

3.  Insert one plug of the Telephone Line cord into the house telephone Jack and the other end   

              into the Telephone Line Connection Jack at the back of the base unit. (If you have an older   

            4-prong Telephone jack, you will need an RJ-11C Telephone jack adaptor. this adaptor is   

            available at the same place you purchased your telephone)

Battery Installation 

1.         

Install the Handset Battery Pack by plugging it into the Battery Connector inside 

the   

                  Battery Compartment.   

2.       Place the Battery Pack inside the Battery      Compartment. 

3.       Slide the Handset Battery Compartment   

Cover firmly into place in its closed position. 

4.       IMPORTANT: Before initial use, charge the Handset for 12 

         hours. Place the  Handset on the Base Unit and make sure  

         that the CHARGE LED  indicator  on the Base Unit lights up.