INSTALLATION INSTRUCTIONS
INSTALLATION DIAGRAM
1. Select a mounting area where the crossover
will be accessible for occasional adjustment of
control settings.
2. Place the crossover on the mounting surface
and mark the locations of the four mounting
holes as shown in the illustration.
3. Remove the crossover and drill a 1/8" hole at
each of the four locations.
CAUTION:
Before drilling the holes, look at the
underside of the mounting surface. Always
check carefully to avoid drilling into wiring,
braces, fuel or brake lines.
CHECK BEFORE
YOU DRILL !
4. Secure the crossover to the mounting surface
using the self-tapping screws and washers
provided.
5. Select a mounting area where the Remote
Subwoofer Level Control will be accessible for
adjustment of the control setting.
6. In similar manner to steps 2 through 4, drill 2
mounting holes and use the self-tapping screws
and washers to secure the Remote Control to
the mounting surface.
-2-
MOUNTING SURFACE
1/8" DIA.
HOLE
SELF-TAPPINGSCREW