This CD Changer is designed to be operated only on 12 volt
DC negative ground systems. The unit can not be used on
24 volt or positive ground systems.
TEMPERATURE
The unit may not operate correctly in extremely hot or cold
temperatures. It is equipped with a built-in thermal protection
circuit which will stop operation of the unit when the
temperature reaches the pre-set level. If this should
happen, the unit will resume operation when the vehicle
returns to a normal temperature range.
Remove the magazine from the unit when it is not being used
during hot weather. If the discs are left in an extremely hot
car they may warp. If the CD changer is not used for long
periods of time, remove the compact discs from the
magazine, and store them in their cases.
CONDENSATION
Moisture can condense on the laser lens of the CD changer
during rainy and humid days, or right after the heater is turned
on in the car (if the changer is mounted in the passenger
compartment). If this should happen the unit will not operate
correctly. To remedy the situation, remove the discs from the
unit and wait approximately one hour. During this time the
moisture will evaporate and the unit will operate normally.
INTERRUPTIONS IN SOUND (Skipping)
The sound from the unit may "skip" and be interrupted if the
anti-vibration springs are not set correctly, if the changer is
mounted on-end or upside-down, or when travelling on very
rough road surfaces. If this should occur, check for errors
made during installation or wait for the road surface to
improve.
3" (8cm) CD-SINGLES
This unit is not designed to play 3" (8cm) CD-Single discs.
Inserting a 3" disc into the magazine, either with or without a
3" disc adaptor, can damage the changer and the disc. Such
damage will not be covered by the Warranty on this product.
HINTS FOR CORRECT AND SAFE
OPERATION
1
