pattern will be repeated three times indicating the new code (52) has been accepted and
stored in memory.
NOTE: If after step 7, the LED flashes a code other than what was just entered, this
indicates that the code has not been changed. You will have to repeat steps 1
through 7 above being certain to note the following:
Acceptable digits 10ths or units are 1 through 9. The unit will not recognize a 0 (Zero), or no
digit entered in any place, units or tenths.
NOTE: If 15 seconds of inactivity expire, or if the ignition switch is turned off for more then 5
seconds during any of the above steps, the unit will revert back to the last success-
fully stored code.
MANUALLY OVERRIDING YOUR SYSTEM:
USING THE CUSTOM CODE OVERRIDE
Assuming the override code programmed has not been changed, and the default override
code of 11 is in the system's memory.
1) Enter the vehicle and turn the ignition switch to the on position.
2) Within 5 seconds, press and release the push-button switch 1 time.
3) Within 5 seconds, turn the ignition switch off then on.
4) Within 5 seconds, press and release the push-button switch 1 time.
5) Turn the ignition switch off then on and start the vehicle. (If optional parking light relay
was installed, the lights will flash twice.)
Note: If you have changed the programmed override code then substitute your new code
tenths for step 2 above, and units for step 5 above.
OPTIONAL DEVICE OUTPUT ( CHANNEL 3 )
Controlled By:
o
Option Button,
o
Both Lock & Unlock Button,
o
Both Option & Lock
Button, or
o
Both Option and Unlock Button.
This security system is equipped with an output which will activate when the appropriate
transmitter button is depressed for 4 seconds. Optional devices that may be connected to
this channel are;
o
Remote Electric Trunk Release
o
Remote Car Starter
o
Remote Window Closure
o
Remote Garage Door Interface
NOTE: In addition there may be a second optional feature connected to your system that
when the same transmitter button is pressed and released 2 times within 3 seconds
(double pressed), the second optional feature will activate. This output is typically
used for a remote start option and will likely prevent inadvertent activation of the
remote start device if young children are playing with the hand held transmitter.
If your vehicle is not equipped with an electronic trunk release switch, or other option listed,
this feature may have been connected to another accessory. Please ask your dealer for
further information.
-5-
