8
2. Video Input Jack
This jack accepts the yellow RCA plug from the
SDBSC cable and applies the video signal from the
source component (Example VCP, DVD etc.).
3. Source Component 12 VDC Output
This jack accepts the black barrel type power con-
nector from the SDBSC cable. (This supplies power
to the source component).
4. IR Repeater Output
This jack accepts the 3.5mm mono plug of the
SDBSC. (NOTE: The IR repeater in this system may
not work with non-Audiovox components.)
5. Power Supply Input
This jack accepts the Molex 6-pin connector from
the Signal Distribution Box Power Cable.
the volume up/down buttons and the Select
button will illuminate). (Note: Some LCD
screens such as the LCM0505, 0565, 4000 and
5000 require that the power button on the
screen be turned on in order to view program
material after the Main Power button on the
control station is pressed).
3.
Select the source you wish to view by pressing
the “S” button on the control station. (Note:
Pressing and holding the “S” button for more
than six seconds will pass infrared control of
the sources to the control station. The source
LED will start blinking to indicate that that con-
trol station has control. A remote control can
then be used to control that video source when
it is pointed at the control station.
4.
Turn on the source to be used (VCP, DVD etc)
either manually or by the remote control for
that device.
5.
Plug in a set of wired headphones into the con-
trol station to listen to the selected source. Use
the volume up (+) and volume down (-) but-
tons to adjust the volume to the wired head-
phones.
6.
Repeat steps 1-5 for each additional control
station and monitor.
OPERATING THE SDB45 SYSTEM
(Without the Master Control Station)
Control Stations:
A. Turning the SDB45 On and Off:
1.
Turn the ignition key to the ON position.
2.
Press the Main Power on the Control Station
(The Power symbol will light up bright red and
3 – IG NIT IO N (R ED )
2 – CO N S TA N T (YELL O W )
1 – G N D
1
2
3
2
1
1
