-
9-
128-6423
9 of 16
CHANNEL SET UP
In order to easily access all available TV channels, it
may be necessary to perform channel auto-
programming whenever the vehicle’s geographic
location has changed, i.e. city to city, weak signal area.
1. Press the AUTO MEMORY button on the Remote
Control Unit or the AUTO PROGRAM button on
the drop down video unit. You will see the TV
cycle through all its channels. The built-in
microprocessor will automatically note each
channel that is actively broadcasting in your area.
2. (A) To tune only strong clear channels with the
CHANNEL UP/DOWN buttons, press the SKIP/
SEARCH button on the Remote Control until
“SKIP MODE ON” is displayed on the bottom of
the screen. In this mode the TV will tune only to
strong active channels when the UP or DOWN
buttons are used on the monitor or remote control.
3. (B) To tune weak or marginal channels with the
CHANNEL UP/DOWN buttons , press the SKIP/
SEARCH button on the Remote Control until
“SKIP MODE OFF” is displayed on the bottom of
the screen. Tune to the desired channel using
the CHANNEL UP/DOWN buttons or go directly
to the channel by using the 0-9 buttons on the
Remote Control.
4. To ERASE a channel, press the ERASE/WRITE
button on the Remote Control Unit until “MANUAL
MEMORY XX ERASE” is displayed on screen.
To STORE a channel, press the button until the
MANUAL MEMORY XX ADD is displayed on
screen.
Note :
Please refer to page 3 for more information on
TV reception.
Turning the VOH703 On or Off
1. Sliding the screen release lock forward will unlock
the LCD screen
causing it to
drop down slightly. Pivot
the screen downward until a comfortable viewing
angle is reached. The internal friction will hold the
screen in position while the system is in use.
2. Pressing the power button on the unit or the remote
control will turn the system on or off alternately.
When in use the internal backlighting will illuminate
the controls.
3. After the unit has been turned on and the picture is
displayed, adjust the viewing angle, by pivoting the
screen to optimize the picture quality.
4. Remember to turn the unit off and return the LCD
display back to the locked position when not in use.
