When the Rota-Kit is beeing installed before the projection screens, the following minimum
tolerance can occur. The tolerance is caused by the resolution of the digital measurement of
the Rota-Kit. The projection screen can be lined out if neccesary with the Rota-Kit.
Ones the positions are set, the accuracy of positioning will be very high. See below the
tolerance measured out in a scheme.
Projection tolerance when repositioning:
Projection distance
Tolerance after
placement
5 meters
+/- 1 mm
10 meters
+/- 2 mm
15 meters
+/- 4mm
20 meters
+/- 8mm
The tolerance is the difference between the programmed position and the actual reached position.
The shown tolerances are indicated and can only be less then shown.
1.
When mounting the Rota-Kit to the ceiling, be aware that the Rota-Kit is installed level.
Be aware of the right direction of the “0” position of the Rota-Kit.
The Rota-Kit has a blind spot of 10 degrees.
Be aware the “0” position is pointed to a non used projection angle.
