The wired control can be connected to the green Phoenix connector.
4a
.
Mount the projector mount to the projector and mount this assembly to the rota-kit.
Connect the power adapter to the Rota-Kit.
The Rota-Kit will automatically go to it’s “0” position.
Note:
Mount the projector (or other AV equipment) cables in a
way that they are clear from moving parts.
Pre-programming the first position:
Rotate the Rota-Kit for about 10 degrees away from it’s “0” position (homing position).
This can be done by using the wired controll or press
on the key-board.
Set the temporarely first position. Press button
and within 1 second button
.
Aim the projector by loosening the ball joint. When the correct position is found, lock the
ball-joint firmly.
Tip: Always programm the latest position firt. The programm the first position. In this way the
programming will alwys be the most accurate. When using the product, always start form
position 1 to 2 or position 3. When returning form position 4 to 3, stop first at 2, then go to 3.
This will give a higher accuracy of positioning.