FAQ:
-The Rota-
Kit doesn’t memories the programmed positions.
The Rota-Kit is always tested before shipment. It might be possible that the sensor connector
is disconnected or not connected properly. This connector can lose its position during rough
transport or installation.
-Remove the black Rota-Kit cover. Beware of the flat cable!
-Confirm the position of both connectors (motor and sensor).
Clean them if necessary with contact spray.
-Reinstall the cover.
-Test the programming
-The Rota-
Kit does not find its “zero point” when the power has been reconnected to the Rota-Kit.
Disconnect the green connector from the Rota-Kit to exclude possible wirering problems
between Rota-Kit and control systems like Crestron / AMX.
Make sure the product is tested as an individual.