General information
18
13.4
Memory position control
Memory position M1 to M4 can be set in three different ways.
By the keypad on the electrical control box
By the memory and motor control terminal
By serial communication via RS-232
In program number “
1
” M3 and M4 are protected and can only be stored using a
PIN-code.
Set the memory position by the keypad
13.5
Error reset
All errors can be reset by disconnecting the power from the control board.
Take at least 10 seconds to power up.
The only exception is if two control boards are in twin mode.
If an synchronous error occurs then both motors have to be reset and homed
separately. Taking into account of mechanical damage.