12
USER'S MANUAL
5.5.1.
SPEAKER IN Hi-level MULTICHANNEL (max 12 CHANNELS)
MASTER SPEAKER IN input selection
1.
Through the
DRC MP
, selecting the
MASTER
input.
2.
Through the
MASTER
input, using the
bit One HD Virtuoso
PC software.
*
CH1-CH2: Auto Turn On System (ART)
WARNING:
the digital inputs accept up to 192 kHz / 24 bit stereo PCM signals. So DOLBY DIGITAL (AC3)
multi-channel signals coming from audio/video sources (such as the audio of a film in DVD) or DTS can
not be reproduced. The output of these devices will therefore be set in STEREO mode for the signal to be
reproduced.
*
Remark:
when performing the installation of fiber optic cables, the minimum bending radius should be 40 mm.
A bending with higher radius value may cause the cable to break and the consequent disruption of the digital signal.
OPTICAL 1/OPTICAL 2 inputs selection
1.
Through the
DRC MP
, selecting the
OPTICAL 1 / OPTICAL 2
input.
2.
Through the OPTICAL 1 SEL / OPTICAL 2 SEL terminal properly set up
This control is activated by connecting the terminal at + 12V.
3.
Through the selection of the OPTICAL 1/ OPTICAL 2 input via the
bit One HD Virtuoso
PC software.
4.
Through the selection of the OPTICAL 1/ OPTICAL 2 input on the OEM source, using the “Auto Input Switch”
function, via the
bit One HD Virtuoso
PC software
AU
X
S/PDI
F
0.1V
2.0V
O
PTICAL O
UT
O
N
+ -
Rem
+ R
ANALOG OUT
Not Supplied
Not Supplied
S/PDIF OUT
75 Ohm Coax Cable
COAX S/PDIF
24 bit 192 kHz max
OPTICAL S/PDIF
24 bit 192 kHz max
*
5.5
HIGH-LEVEL INPUT SIGNALS
bit One HD Virtuoso
Bottom Side
SDC
DRCC
OEM
AMPLIFIER
OEM
HEAD UNIT
MAX 12
CHANNELS
INPUT
*
5.6
OPTICAL 1/OPTICAL 2 DIGITAL INPUT SIGNALS
5
