40
USER'S MANUAL
Speakers can be selected just by clicking
on them. The software assumes that
if you select left tweeters, midrange
or woofers, the right ones will also be
activated automatically. This choice will
affect, once the software is started, the
type of dedicated virtual crossover.
Remark:
if you selected the FIR mode the
bit One HD Virtuoso will have a
maximum of 9 out channels to enable.
Pass through 1:1
IIn this configuration the number of output channels is equal to the number of input channels. So
if you have 8 channels in input it will be possible to have a system with 8 channels in output. The
Software, however, will make other speakers available to increase the ways
(see following point)
.
Extended PASS THROUGH
In this configuration compared to the previous one it was decided to extend the number of output
channels with respect to the same input configuration. In fact we would have 3 channels Front Out
stereo compared to 2 channels Front Input stereo, and 2 channels Rear out Stereo compared to a
Real Full stereo system.
-
Press
BACK
to go back to the previous step.
-
Press
NEXT
to continue with the configuration.
-
Press
CANCEL
to exit.
At the end of the setup
8.
Selection of the speakers available in the system
7
