23
USER'S MANUAL
At this point it is necessary to know in advance the system that you intend to create, since later, to
modify these selections, you will have to run a guided procedure.
More specifically the guided procedure will request:
-
Which type of output filter to use: FIR or IIR. Remark: in the FIR mode you can have a maximum of
9 output channels.
-
Whether to choose between an output system with reconstruction of the input front or PASS THROUGH.
-
Whether or not to perform a complete analysis of your OEM audio system, in order to maximize the results.
-
Which types of main entrances will be used, whether at high level or low level. This choice will not
prevent the use of low-level or digital auxiliary sources. The guided procedure changes according
to the selection.
-
If you intend to turn on the product via “HI LEVEL TURN ON” (ART).
-
Which auxiliary inputs will be used (i.e.: AUX o OPTICAL IN … etc.).
-
What kind of signals will be assigned to the main inputs (i.e.: Front Left or Center or Subwoofer etc.).
-
Which speakers make up the system (i.e.: 3-way Front or Sub stereo or 2-way Rear etc.).
-
If there are passive crossovers that manage groups of speakers (i.e.: 3-way system with active
medium-low).
-
If there are amplifiers connected via the AC Link.
Select the operating mode between IIR o
FIR.
-
Choose Automatic Routing for the
reconstruction of the automatic fronts
-
Select Pass through
if
you intend to interface with complex
OEM audio systems, featuring surround
systems, and audio customization
algorithms.
This mode will allow you to maintain the
main performance of your OEM system,
interfacing it 1 to 1 or extended.
This mode will also allow the OEM
source to be released with respect to the
available auxiliary inputs (Optical / AUX),
creating a new system that is completely
independent from the OEM one, being able to customise the other sources available in a more complex way.
Remark:
when selecting the PASS THROUGH mode, set the memory relating to the OEM master input.
Click on the
Config menu
and select
I/O Configuration Wizard
.
7.2.1
I/O CONFIGURATION WIZARD
WARNING:
during this operation it is advisable to disconnect the
RCA / AD LINK - AC LINK
sockets
of the bit One HD Virtuoso, connected to the amplifiers.
Configuration wizard for the system to be implemented
Press
NEXT
to continue with the configuration.
Press
CANCEL
to exit.
7
