48
USER'S MANUAL
Selecting the “File” tab a drop-down menu shows up listing the
entries as shown in the image to the right of this page:
The software allows the user to upload a file saved in FIR
mode in IIR mode, converting the equalization curves of the
Channels EQ and maintaining the settings of the inputs and
the specialization of the outputs. Obviously when going from
FIR to IIR small adjustment setups are necessary concerning
the electrical phases of the output channels (Invert Phase).
The reverse operation, loading an IIR file in FIR mode, is not
contemplated.
-
Select
YES
to load a FIR setup in IIR mode.
-
Select
NO
to load a FIR setup.
-
Select
Cancel
to cancel the operation.
1.
Load Setup:
by selecting this entry, the
bit One HD Virtuoso entire setup is loaded from a
previously saved file (EX. “BitOnehdConfig1.bhd”).
This feature is available both in
TARGET
and
OFFLINE
mode. In
TARGET
mode this function
provides the ability to load again all the settings
that have been previously saved. It is useful
if you want to resume all the settings you have
previously selected to install another bit One HD
Virtuoso with the same adjustments, in order to
test different acoustic settings
.
2.
Save Setup:
it enables the storage of the
entire bit One HD Virtuoso configuration in a file
(EX. BitOnehdConfig1.bhd”) that you can
subsequently load into the bit One HD Virtuoso
through the Load Setup function. This feature is
available both in
TARGET
and in
OFFLINE
mode.
1
2
3
4
5
6
7
8
9
10
11
14
12
13
1
8.2
MAIN MENU: “FILE”
8
