8
USER'S MANUAL
1.
POWER SUPPLY / REMOTE IN-OUT
+BATT 12V:
positive connection terminal for car 12V power supply
-BATT:
negative connection terminal for car 12V power supply.
REMOTE IN:
for the processor remote turn-on through one or multiple signal sources, featuring Rem Out control.
REMOTE OUT:
for the remote turn-on of the other devices/amplifiers connected to the processor.
The REMOTE OUT output has a current capability of 130 mA (it can also drive an automotive relay).
The processor only takes 7 seconds to supply the REM OUT to the output after turn on.
WARNING:
make sure the connection polarity is as indicated on the terminals. A misconnection may result in
damage to the
bit One HD Virtuoso
. After applying a 12V power, wait at least 10 seconds before turning the
bit One HD Virtuoso
on.
WARNING:
the
bit One HD Virtuoso
must be switched on before the amplifiers connected are turned on. It is
necessary to connect the sources Remote Out to the
bit One HD Virtuoso
Remote In and then the
bit One HD Virtuoso
Remote Out to the Remote In of the other devices / amplifiers connected to the
bit One HD Virtuoso
Remark:
the Remote Out signal is available on the AC LINK 1 / AC LINK 2 connection plugs and is active to the
amplifiers supporting this function (Audison AV amplifiers with AV bit IN input).
2.
DRC:
connection plug for the DRC MP (Digital Remote Control), to control the processor’s functions
3.
DRCC:
terminals for future use.
4.
SDC:
terminals for future use.
7
8
9
6
2
3
4
5
1
SDC
DRCC
4.3
INPUTS - REMOTE CONTROL OUTPUTS AND POWER SUPPLY
4