7
F
OPTICAL/AUX SEL BROWN:
this terminal can be used for
AUX
and
OPTICAL IN
on the products with
OPTICAL/SEL AUX SEL
activation input.
G
STATUS LED PINK:
connect a LED
(not supplied)
as shown in the figure
(optional)
. This LED duplicates
the one in the infrared receiver sensor
(see section 2)
. If the LED flashes, the product is processing information
and is not ready, while if it starts normally the bit Play HD is ready for use.
H
REMOTE OUT - BLUE/WHITE:
output to remotely control other devices/amplifiers connected to the bit Play HD.
After turning on, the device takes 2 seconds to output the REM OUT signal. This output has a current
capacity of 130 mA.
I
STEERING WHEEL CONTROL:
terminals for future use.
IR REM CONTROL:
connector for the infrared receiver of the bit Play HD remote controls supplied with the
product. Point the remote at the sensor from within 2 meters
(see sections 3.1 and 3.2)
. The sensor incorporates a
green status LED. If the LED flashes, the product is processing information and is not ready. If it starts
normally, the bit Play HD is ready for use.
FUSE:
blade 3A protection fuse. If you need to replace the fuse, use only the same type and value of the original.
OPTICAL:
connect a fibre optic cable with a TOSLINK connector to a processor or Audison amplifier with S/PDIF
optical input. In this way, you create a Full DA system capable of achieving a new quality benchmark that goes
well beyond the CD standard, since you can play FLAC encoded audio files up to 24 bit/96 kHz. This output is
subject to volume control via the remote or APP for mobile devices
(see section 6.)
.
VIDEO:
composite video output for an external monitor, 75-Ohm impedance. Connect an RCA male cable with
75-Ohm impedance to an external monitor. The external display is enabled by connecting the consent
terminal (active at +12V) to the power supply of the monitor (Max. Consumption 1A) or to the appropriate
monitor terminal. Default resolution set to 480P; to modify the video resolution
see section 7.2
.
INFRARED RECEIVER
STATUS LED
bit Play HD OPERATE
... WAIT
WARNING:
if you choose to use the bit Play HD using the APP, the management via remote control may be disabled.
USER’S MANUAL
bit Play HD /
2
3
4
5
3A
2
