M55D
M55D
FIGURE 6
Connect the DN4/DN43 Dante-AES67
interface to a PoE switch (see DN4/
DN43 guide).
FIGURE 1
Drill a 3/4” (19mm) hole in the ceiling
tile. Place cylinder on top of hole after
removing the lid, and insert M55D collar
through the hole. Fasten nut.
FIGURE 3
Insert category cable into RJ45
receptacle of M55D and DN4/DN43
mic input. Use Audix Cat7 or shielded
category cable.
FIGURE 2
Plug in 7 pin microphone connector
into mating receptacle as shown above.
Refasten lid.
FIGURE 4
Seismic cable installation; Insert cable
through the top of cable stay barrel
pulling excess cable until taut.
Place
cable eyelet under brass screw and
fasten.
FIGURE 5
Connect up to four microphones to the
Audix DN4 or one M3 and one single-
channel microphone to the Audix DN43
interface.
INSTALLATION
