Audix M70-W Installation Manual Download

Page: 3 / 4

MOUNTING AND WIRING INSTRUCTIONS

FOR M70

To adjust microphone,

unscrew the grill assembly.

Wiring:

1 = Ground

2 = Blue (+)

3 = Yellow (-)

Open back lid of junction box.

Separate the supplied phoenix

connector (male/female).

Connect Phoenix terminals.

Insert plenum cable through

strain relief nut, then connect to

the Phoenix terminal.

Recommended cable:

Belden 9451P - .124" O.D. or

Belden 82761 - .116" O.D.

Tighten down the strain relief

nut to hold wire firmly in place

and close junction box lid.

For further information contact Audix at 503.682.6933

www.audixusa.com

2 1

Summary of Contents for M70-W

Page 1: ...AL MICROPHONES AUDIX M70 INSTALLATION GUIDE Thank you for choosing Audix Our products are designed to provide you with many years of reliable service Please read this manual before using the system for optimal installation and operation ...

Page 3: ...x connector male female Connect Phoenix terminals Insert plenum cable through strain relief nut then connect to the Phoenix terminal Recommended cable Belden 9451P 124 O D or Belden 82761 116 O D Tighten down the strain relief nut to hold wire firmly in place and close junction box lid For further information contact Audix at 503 682 6933 www audixusa com 3 3 2 1 2 1 6 3 1 4 2 5 ...

Page 4: ...BLE RELEASE PIN PLENUM RATED BOX PLENUM RATED CABLE Wrap the cable around a beam eyebolt or hanger Next slip the cable through the top of cable stay barrel pulling excess cable until taut To release cable depress the cable release pin on top to release the loop or on bottom to extend cable length g g g g g g g g g g g g g g g g g g LITJBM70 8 13 ...