-
installer
GIALIX 24 MA C -BC
manual
-
28
4.1.3.3.2 - Automatic operation
The heating water temperature is based on the
exterior temperature.
To operate in automatic mode, the Gialix boiler must be
connected to an exterior sensor which is set-up in consequence:
Simultaneously press both
and
for 3 seconds
until parameter
01
appears flashing on the upper
display screen.
Press
until parameter
07
appears on the upper
display screen.
Press
or
, to access the settings to modify the
parameter’s value. This value appears flashing on the
lower display screen.
Press
or
to enter the value
01
on the lower
display screen.
Press
or
to confirm the parameter’s value.
Simultaneously press
and
for 3 seconds to
exit settings.
Check that the boiler is set to operate in automatic mode.
Press
.
Press
again until parameter
A
U
is displayed.
Press on
once more for 3 seconds to confirm the
choice.
The boiler is now operating in automatic mode.
4.1.3.4 - Manual operation
SUMMER or WINTER
4.1.3.4.1 - SUMMER mode operation
Press
for 3 seconds.
The green LED for summer mode will turn on.
In summer mode, only the domestic hot water function is
provided. Every 24 hours, the circulator pump will run for 1
minute to prevent blocking of the circulator.
4.1.3.4.2 - WINTER mode operation
Press
for 3 seconds.
The green LED for winter mode will turn on.
4.1.3.5 - How to set your heating
If your boiler is set for automatic operation, this function is not
available.
Set your boiler in manual mode to adjust your heating settings.
Then:
Press
, the boiler’s set temperature is displayed
flashing on the upper display screen.
Press
or
to set the desired heating
temperature.
Press
to confirm the new heating temperature
and to return to the normal boiler display screen
(Temperature of outgoing heating water shown on
the upper display screen, and the pressure in bars on
the lower display screen).
4.1.3.6 - How to set the temperature of
domestic hot water
This setting is only possible with a DHW sensor. Otherwise, it is
carried out with the DHW aquastat.
Press
the temperature of the domestic hot water
is displayed flashing on the upper display screen.
Press
or
to increase of decrease the set
temperature within the set range of 20 to 65°C.
Press
to confirm the set temperature.