Commissioning
50
COMfortel 3500 - Firmware Version 1.2B - Commissioning Instructions 02 07/12
2.
Insert the other plug of the patch cable into the outgoing jack on the DSL
router/switch or into an existing network mains outlet.
3.
If required, insert the power supply plug(s) into a freely accessible 230 V
network mains outlet.
The telephone starts up. In the meantime, the LED above the display
turns red and the Auerswald company icon is shown on the display.
If a DHCP server has been configured in the local network, the tele-
phone automatically receives its IP address, subnet mask, as well as
the gateway and DNS server addresses from this DHCP server during
a DHCP request.
The telephone searches for an Auerswald PBX in the network.
The setup assistant is automatically started.
The dialogue box to select the language is opened (only during the in-
itial start-up of the telephone).
4.
Tap on the required language.
If the telephone has found an appropriate PBX, an account (e. g.
Account 001) will automatically be created for this PBX and will be dis-
played in the setup assistant under Inactive or unregistered ac-
counts.
Note: Please observe the following notes if your telephone shows a differ-
ing or unexpected behaviour.
If the message Faulty network setup is shown on the display, this indi-
cates that the DHCP server is missing. You can also operate the telephone
with a permanent IP address. To do this, proceed as described in
Fig. 10: Connecting the patch cable (here for the operation with Power over
Ethernet)
Summary of Contents for COMfortel 3500
