COMmander 6000/R/RX - Firmware V7.0D - Advanced Information V19 04/2018
663
Settings – Groups
Properties
call, this subscriber will immediately ring again for the pending calls. The
timer for the configured delay time (
after:
) starts after receiving the first call
to the group and will not restart for additional incoming calls.
Linear - fixed - Split Group
Only the phone of one group member will ring. After the configured delay
time (
after:
) another single group member will be called. The order of calls
depends on the configured
Priority
. If a call was not accepted, although all
logged-in members of the group were called, the call would be finished with
a busy signal.
Linear - balancing - Split Group
Only the phone of one group member will ring. After the configured delay
time (
after:
) another single group member will be called. The order of the
calls depends on the configured
Priority
: First of all the member of the
group first logged-in gets the position 1 in the order of calls, the second one
the position 2, ... . If position 1 takes a call, the second call will be assigned
to position 2. The member of the group with the position 1 will get the last
position in the order for a future call after he has finished the current call. If
a call was not accepted, although all logged-in members of the group were
called, the call would be finished with a busy signal.
Linear - fixed - rotating - Split Group
Only the phone of one group member will ring. After the configured delay
time (
after:
) another single group member will be called. If all members of a
group are called, the process will be restarted with the first member of the
group of the call order. In the first rotation the next member of the group of
the call order will be called immediately if a subscriber is busy. In the second
rotation the busy subscribers will hear knocking (only from external). The
order of calls depends on the configured
Priority
.
Linear - balancing - rotating - Split Group
Only the phone of one group member will ring. After the configured delay
time (
after:
) another single group member will be called. If all members of a
group are called, the process will be restarted with the first member of the
