COMmander 6000/R/RX - Firmware V7.0D - Advanced Information V19 04/2018
731
Settings – Devices
Device Wizard
To change the settings of the configured COMmander 2TSM (R)
module, click
Configure
in the line of the corresponding COMmander
2TSM (R) module on the page
Devices > Device wizard
.
To reset the COMmander 2TSM (R) module to the default settings of the
device template, on page
Hardware > Selection of modules
, select the
option
not defined
and then again
2TSM module
in the corresponding
list field. Subsequently, open the page
Devices > Device wizard
and
configure the COMmander 2TSM (R) module again.
Door Terminals
An existing door terminal can be connected to the PBX so that various door
functions such as speech connection with the door and actuation of the door
opener from internal phones can be carried out. This door terminal must be
created in the configuration of the PBX and allocated an internal number
where it can be called.
The door terminal and the relays and switch inputs (door bell buttons)
available for it can be created with the device wizard. Door calls can be
created for the switch inputs of the door terminal by selecting call destina-
tions. To detect their actuation e. g. because a door bell button has been
