12
Mount the Case onto the Wall
The installation material (screws and wall plugs) as well as a drill tem-
plate is part of the extent of supply.
왎
Hold the drill template onto the place where is should be mounted
and mark the drill holes on the wall. There are three holes available
for wall mounting.
왎
Make sure that around the marks no hidden supply pipes or cables
are in the wall.
왎
Drill the holes with a diameter of 6 mm and put the dowels into the
holes.
왎
Screw the two top screws into the wall until the screw heads have
app. 5 mm distance to the wall.
왎
Now you hang the PBX on the screws and pull it on the wall down-
wards until it stops.
왎
Screw the PBX with the third screw into the bottom dowel. (see
Connect an ISDN telephone directly to the western modular jack
1
called
„S02 int.“ or use an ISDN distribution jack such as e.g. the ISDN Multi-
plug (Auerswald accessory) to connect multiple ISDN devices (see
Connect up to three analog telephones directly with the three TAE
jacks
2
at the right side (see
If the distances are longer than 10 m you have to lay an inter-
nal S
0
bus for the ISDN telephones. These and additional
facts are described on
If the analog telephones work on a longer distance to the PBX, the con-
nection is done via wall jacks connected to the analog screw clamp.
These and other facts are described on
Mount the Case onto the Wall
5 mm
Abb. 3: Distance of the screws to
the wall
Pic. 4: Screw the case onto the wall
Connect the Telephones
1. Technical modifications in the layout may lead to a change in the position of the
ISDN jacks and clamps.
2. Outside of Germany Western modular jacks (layout diagram
Pic. 5: Connect analog Telephones
☞
Pic. 6: Connect ISDN Telephones
Summary of Contents for COMpact 2206 USB
Page 66: ...884250...
Page 67: ......
Page 68: ...884250 03 03 04 Save the Earth 100 recycled paper...
