auna 0031015, Manual

13

EN

SETUP

1. 

Place the unit on a flat and level surface. The selected location should be 

stable and free from vibration.

2.  Fit the drive belt around the sub-edge under the platter and the spindle 

of the motor.

3.  Remove the tie-wrap that is holding the Tonearm (5).
4.  Place the slip mat on top of the Turntable Platter (2).
5.  Connect the Speaker Wire (18) to the turntable’s Speaker Output 

Terminals (15) correspondingly. Make sure the left and right channels are 

connected correctly.

6. Connect AC adaptor to the Power Jack (14) of the unit.

STEREO SYSTEM CONNECTION

1.  The RCA Line Out Jacks (16) output analog line-level signals and could 

be connected directly with a pair  of active/powered speakers or the 

appropriate input of your stereo system.

2.  The Red plug connects with the Right channel and the White plug 

connects with the Left channel.

NOTE: The RCA Jacks are not designed to be connected directly to the 

passive/ unpowered speakers. If connected to the passive speakers, the 

volume level will be very low.

TURNTABLE OPERATION

1.  Turn the Volume Knob(12) to turn on the unit.
2.  Rotate the Function Knob(10) to either 33 1/3 or 45 RPM mode to select 

the turntable speed accordingly. Use the 45 RPM Adapter(1) if necessary.

3.  Place the record on the Turntable Platter(2).
4.  Remove the stylus protector from the Cartridge(13).
5.  Lift up the Tonearm(5) and move it over the record where play is desired 

to begin. Gently  put down the Tonearm(5) and begin the playback.

6. 

When the record is finished playing, gently lift up the Tonearm(5) and 

move it back to the 

Tonearm Rest(7). To suspend the playback, repeat the same steps.
Note: To avoid stylus damage, make certain the included stylus guard is in 

place whenever the turntable is being moved of cleaned.