12
EN
LISTENING TO PHONO
1 Remove the stylus protector.
2 Be sure that the tone arm is being detached from the tone arm rest
before operating and re-secured again afterwards.
3 Select to “ phono ” function.
4 Set the speed selector to the proper position depending on the record
to be played.
5 Place the record on the platter (use the spindle adaptor if required).
6 Lift the tone arm from the rest and slowly move it to the record side.
The platter will start to rotate.
7 Place the tone arm to the desired position of the record.
8 Adjust the volume to the desired level.
9 At the end of record, the platter will automatically stop rotating. Lift the
tone arm from the record and return it to the rest.
Tip
: To stop manually, lift the tone arm from the record and return it to the
rest.
As some kind of record the auto-stop area was out of the unit setting, so
it will stop before the last rack finish. In this case, select the auto-stop
switch to “ off “ position, then it will run to the end of the record but will
not stop automatically (turn off the unit by power button or switch back
the auto-stop switch to “ on “ position to stop the platter rotate). Then
put back the tone arm to the rest position.
LINE OUT CONNECTION
You can connect the system to your whole hi-fi system by connecting
the line out socket (13) to the auxiliary input socket with a rca cable (not
included).
Remark: the sound from the original build-in speaker will not be
terminated even after connecting to other hi-fi system via line out
socket. You can turn the volume of system to minimum level if you prefer
the sound coming from the hi-fi system only.
