38
EN
FM RADIO
If you are not already in FM mode, repeatedly short press the Source
button to go to FM mode (check the display). If you were listening to an
FM station when you switched the product to standby mode then this
station will be automatically selected when you switch the product back
on.
Wire radio aerial
Please make sure that the wire aerial on the back of the Retro turntable
is fully extended and adjusted before you attempt to tune to an FM radio
station (a vertical position is recommended). This will ensure that the
maximum signal strength is available when the product begins to scan.
Extending the aerial also ensures the best possible sound quality.
Tuning to an FM station
In FM mode:
Long press the Tune/Skip + button to scan up the frequency band.
Long press the Tune/Skip - button to scan down the frequency band.
Short press the Tune/Skip + or - button to adjust the frequency band in
0.05MHz steps.
Note: If reception is poor check that the wire aerial is fully extended or
try moving the product to another location.
Storing an FM station preset
Your Retro Turntable can store up to 30 FM stations in its preset
memories for instant access to your favourite stations.
1. Tune the Retro Turntable to the FM radio station that you wish to
preset.
2.
Long press the Repeat button until ‘P XX’ starts to flash on the display
(where XX is the preset number).
3. Short press the Tune/Skip
or
, button to move to the preset
number that you would like to store the radio station to (1-30).
4.
Short press the Play button. ‘P XX’ will stop flashing confirming that
the preset has been stored.
Note: If there is already an existing FM station stored under a preset, it
will be overwritten when you store new stations.
