44
EN
Note: If you do not use or pause your Retro Turntable for approximately 20
minutes and no audio signal is received, it will automatically go to Standby
mode.
AUX IN MODE
Check that your Retro Turntable is in Aux in mode. If you are not already in
Aux in mode, repeatedly short press the Source button to go to Aux in mode
(check the display).
Using a 3.5mm audio input connection cable (not included), Aux in allows
for a quick and easy connection to an external sound source.
1. Connect one end of the 3.5mm audio connection cable to the headphone
(or auxiliary out) socket of your secondary device, connect the other end
to the Aux in socket on the front of your Retro Turntable.
2. Press the Play button on your external device to start playback through
the Retro turntable speakers. To gain optimal volume levels, adjust the
output volume level on both the secondary device and on the Retro
turntable.
Note: It is recommended that you unplug the Audio cable from the Aux in
socket after you have finished listening to your external device.
