Assemby Instructions for APT4300 – Aunger 4’x 3’ Trailer
9
11
. Attach the side panels by aligning the panel and the holes in the trailer body (1). The
bolts on the bottom at the rear of the side panel will secure the light board to the trailer (2).
Note: the gatelock mechanism should be at the rear of the trailer
Attach 1x M8* 15 flange hex bolt, 1 x M8 Flat Washer and 1 x M8 Locknut at rear as
shown with the light board panel on the inside (3). Put the washer under the Locknut.
Repeat for other side.
Attach 1 x M8* 15 flange hex bolt and 1 x M8 Lock Washer in bottom of side panel (at the
front) as illustrated (1). Repeat for other side.
The bolts must not be tightened before all the bolts are in place including the ones in the
frontgate. This helps with ensuring all panels line up evenly.
3
2
1
