USER AND INSTALLATION MANUAL
AUPA PLANCHA 3 BURNERS
AUPA Plancha LLC. 2020 Howell Mill Rd, Suite D #180. Atlanta, Ga 30318. USA.
Phone
Fax
404.601.9778 - www.aupaplancha.com
Page 9
Do not ignite burners or use an open flame to check for gas leaks. Be sure there are no sparks or
open flames in the area while you check for gas leaks.
Flames and sparks will result in a fire or explosion which can cause serious bodily injury or death and
damage to property.
Note: All factory-made connections have been thoroughly checked for gas leaks. The burners and
ignition system has been flame tested. As a safety precaution, we recommend you recheck all fittings
for leaks before using your AUPA Plancha grill. Shipping and handling may loosen or damage a gas
fitting.
To perform a leak check you will need a solution of soap and water and a brush or rag to wet all gas
connections.
1. Turn all control knobs to the OFF position.
2. Turn on gas supply and check for leaks by wetting the connections with the soap and water
solution and watching for bubbles. If bubbles appear, or if a bubble grows, there is a leak, and in that
case, please call AUPA Plancha to replace the defective part.
Note: Since some leak test solutions, including soap and water, may be slightly corrosive, all
connections should be rinsed with water after checking for leaks.
CHECKING GAS LEAKS (LP)
