2. Remove the protective tube D
from the cord guide E and slide
the tube off the cord (see fig. 7).
3. Tie a knot in the end of the cord.
4. Pull on the cord at the other side
of the bed.
5. Untie the knot.
6. Pull the cord through the
protective tube (first through the
eye, then through the tube).
7. Hook and pull the protective tube
over the cord guide.
8. Push the cord through the
smaller hole in the ball.
9. Tie a knot in the end of the cord.
10. Pull the control ball over the
knot.
5. Malfunctions
Undesirable noises (bed squeaks
and creaks).
Unwanted noises are usually caused
by moving parts touching each other.
The reason for this may be a missing
part, or parts that have not been
tightened up properly or have
become loose when the bed was
moved.
Check that:
- the bed is properly horizontal;
- the bed is positioned away from the
wall;
- there are no unwanted objects in
the bed that should not be there
(spoons, forks, pens, etc.).
In the unlikely event of the gas
spring failing, the operating cord will
tighten and the back section will be
automatically raised.
GB 7
E
D
fig. 7
6511000 GBA 333B.qxd 30-05-2005 08:39 Pagina GB 7
