14. Protection
1. Should any transmission disturbance due, for
example, to a strong electromagnetic impulse
or voltage drop of
AURATON 2020 TX Plus
battery, prevent the
AURATON 2020 RX Plus
receiver from confirming the ON or OFF
switching within 5 consecutive cycles (i.e. 5
minutes) the heating device switches off. This is
to avoid overheating of the device. After
elimination of the reason of such a disturbance
the controller resumes its normal operation.
Only in case of battery replacement
reprogramming of
AURATON 2020 TX Plus
may be required, should the operation last
longer than 30 seconds.
2. The signal transmitted to
AURATON 2020 RX
Plus
is of digital encoded type. It means that
several
AURATON 2020 TX Plus
controllers
may operate in a small area without mutual
interference.
In case of any doubts please contact the dealer
or manufacturer.
15. Operation of
AURATON 2020 TX
RX Plus
As the transmission undergoes only in one direction
the
AURATON 2020 TX Plus
emits, for security
purposes, a short encoded signal every minute with
a view to confirming the required state of the
AURATON 2020 RX Plus
receiver. This time interval
is permanently set for the microprocessor, no
change is possible.
Note
: The controller may cooperate with an electric,
gas, or oil device of the power exceeding load
capacity of the terminals only through an
intermediate switch of the power and operation
suitable for the end device. In such a case please
consult the dealer or guarantor.
Note
: Avoid high induction and capacity loads as
they result in burning the transmitter contacts out.
AURATON 2020 TX RX Plus
- Protection
50
EN
