II.
INSTALLATION OF RECEIVER
Caution
:
1. The appliance can only be mounted on dry indoor
places
2. A suitable fuse with a rating not exceeding 20A,
should be in the power line
3. Observe the nation regulator for the wiring
4. Qualified electrician is recommended for
installation and servicing
This thermostat has been designed for simple and
quick installation requiring only a few tools. Only
the
Power Control Unit need to be installed.
2.1)
Required Material
Hammer
Masking tape
Screwdriver
Drill and 3/16" drill bit (if not installed on a junction
box)
2.2)
RF Address Code Setting
If there is another user nearby, e.g. in the next
house,
installs the same
AURATON 2100 TX
unit,
your receiver may be fault
triggered by his/her
transmitter. You may select a different
RF address
code to prevent this. Receiver can
only response to
RF coding with the same address
code setting as its
own address code.
1. To adjust address code of Receiver, simply push
up
one or more of the 5 dip switch levers
2. To adjust address code of Control Center, open
the
housing of transmitter unit. See battery
replacement
section on how to open the
housing
6
ARATON 2100 TX