26/10/21, 3:38 μ.μ.
AURATON Tucana - AURATON manuals
https://manuals.auraton.pl/manuals/auraton-tucana-pl/
8/39
Connecting cables to AURATON Tucana
The cable clamps are located on the back of the AURATON Tucana. It is a typical
single-pole two-state relay. In most cases, the NC terminal is not used.
Battery change
X
If the display shows the low battery symbol (
X
), it means that the battery voltage has
dropped to the minimum acceptable level. In this case, replace the batteries as soon as
possible.
Configuration settings
PWM operating mode
Connection diagram of AURATON Tucana
Cleaning and maintenance
Technical data
Disposal of the device
To download
Weekly, wired temperature controller
Description of AURATON Tucana
First launch of AURATON Tucana
Introduction to programming
programming
Manual control
Vacation mode
Setting the anti-freeze temperature program
Heating device operation time counter
Temporary switch off of the relay
RESET AURATON Tucana
MASTER RESET AURATON Tucana
Configuration settings