Aurora AU 3080, Manual

AU 

3080

Hair clipper set

ENG

10

ADJUSTING THE BLADES

The profiles of the teeth of both blades when 

you install must match exactly. The upper edge 

of the real teeth (external) of the blade must be 

nominated by approximately 1.2 mm above the 

edge of the movable teeth (internal) of the blade, 

as shown in the figure. If the blades are not set 

correctly, apply a few drops of oil, turn the clipper 

for a few seconds, then turn it off and disconnect 

from the mains. Loosen the two screws securing 

the fixed (external) of the blade and re him. Ef­

fortlessly, tighten the screws.

LEVER BLADES MOVE

Arm movement of the blade located on the left 

side of the machine and makes it easy to adjust 

the length haircut. During mowing, you can press 

the lever gently to change the length of cut hair 

without the use of additional accessories. At the 

top position of the lever will receive a short hair­

cut. In the lowered position of the lever length of 

the cut hair is the same as when using a nozzle 

of 3 mm. 

GETTING THE BEARD

The best cutting results are achieved when us­

ing dry hair. For the first time better to leave after 

shearing longer hair. Hair length depends on the 

nozzle. Install the nozzle on the blade. For even 

cutting smoothly move the car through the hair, 

do not make sudden movements, cut off one 

pass a small amount of hair, if necessary return to 

the treated area hair re haircuts. Remove cut hair 

from the blades of the machine. Comb hair comb 

to detect uneven strands.

STEP 1

Set the nozzle 1 (3 mm) or 2 (6 mm). Plug in the 

power cord and turn the machine switch. Keep 

the machine so that the blade facing upward. 

Start a haircut from the beginning of hair growth 

(Fig. 1). Slowly move the clipper upward and from 

the head. Cut the thus all the hair from the bot­

tom and back of the head around the ears.

STEP 2

Turn off the machine, set the nozzle for longer 

hair 3 (9 mm) or 4 (12 mm) and continue cutting 

hair near the crown of the head (Fig. 2).

Step 3

Mowing in temples. For the topiary in the tem­

ples, set the nozzle 3 (9mm) or 4 (12mm), start 

from the beginning cut temples and continue 

towards the top (Fig. 3).

Step 4

Mowing in the crown of the head. Using the 

nozzle 3 (9 mm) or 4 (12mm), cut the hair in the 

direction from the top to the crown, against the 

direction of hair growth (Fig. 4). Hair can be cut 

against the direction of growth and the direction 

of growth, but remember that the hair is trimmed 

against the direction of their growth will be short 

hair trimmed in the direction of growth. Use the 

nozzle 1 (3 mm) and 2 (6 mm) for a very short 

haircut. To keep long hair, use a nozzle 3 (9 mm) 

or 4 (12 mm). To leave longer hair, clamp the 

strands of hair between the toes and cut them. 

You can use a comb, lift the hair strands and cut 

them over the machine comb (Fig. 5, 6). Always 

start a cut with the back of the head. Comb hair 

comb to detect uneven strands.