12
Connections to Aurora Universal
This section shows how to tap the 24VDC power and make RS485 connections from an Aurora
Universal management system. Most other monitoring systems will have a means of supplying 24VDC
power. Consult your monitoring system documentation for information.
1.
After making the correct 24VDC and RS485 attachments to the weather station, run
cable from the weather station to the Aurora Universal. Note that connections for
power can be made to the Aurora Universal or directly to another 24 VDC power supply
2.
Connect the
wires for the 24VDC power and RS485 to the Aurora Universal. See the
figure below. Note that some Aurora Universal models may have RS485 connection
points in other locations.
Weather Station Connection to Aurora Universal
System Activation and Validation
If you acquired the Aurora Environmental as part of an Aurora Universal/Aurora Vision product
bundle, please refer to the information that came with your Aurora Universal package. This
information will describe the next steps for product installation and system validation.
The management system must be properly installed and communicating before you can verify that
data is flowing form the Aurora Environmental weather station.
Aurora Universal DIN Rail
Weather Station
Electronics Board
D+ D-
+24VDC
