C200H-HI / C200H x4 / C250H-HI
C250HI LE / C250H x4 / C250H x4 LE
82
Machine cleaning
During the clean operations, not to direct pressure water on the intake (air filter), the
steering column, battery, alternator and other electric devices because can deteriorate
their components.
Breakdown in road (fig. 1)
• In case of breakdown when driving on public roads, warn other users of the road
with the hazard warning triangles (
). They could be stored under the cabin;
raising it.
Engine
For operating instructions, list of spare parts and general maintenance, see the engine
handbooks or the
MAINTENANCE CHART
.
Alternator belt
Check the tension of the alternator belt regularly. Also check for cracks or other damage.
Ref er to an authorized AUSA dealer for the replacement of the alternator belt.
Engine oil
Oil level: Checking
With the forklift on a level surface, while the engine is cold and switched off, check the
oil level as follows:
- Pull out the dipstick and clean on a clean cloth.
- Replace the dipstick in its casing.
- Remove again and check the oil level. This should be at the upper level.
(fig. 2)
.
a- Full
b- Add oil
c- Operating range
- Add oil until the level reaches the upper level.
Oil level: Correct
- Remove the dipstick and place a funnel in the opening of the oil filler neck located
above the rocker arm cover.
CAUTION
Do not exceed the maximum level mark. Starting the engine with incorrect oil
levels may cause serious damage. Clean up any spillage. Check the oil level
often and top up where necessary.
- Top up with oil gradually until the level is correct.
(fig. 2)
(fig. 1)
Periodic
Maintenance
Operations
